SHURE DH5

Name: SHURE DH5 - DuraPlex Omnidirectional Subminiature Headset Microphone
Brand: Shure
Availability: InStock

DuraPlex Omnidirectional Subminiature Headset Microphone

Lightweight and comfortable to wear, the DuraPlex DH5 headset microphone offers a neutral, full sound that will lift your performance, speech, musical, or broadcast. Rely on the DH5 headset microphone in the harshest environments, thanks to its long-lasting Shure Plex cable and a certified IP57 rating, which means you’re protected against water, sweat, moisture, dust, and dirt. Capture every moment with confidence.

Brand: Shure

Product Code:DH5T/O-MTQG

Select a Combination

Wish List
Compare

5 mm omnidirectional subminiature design for discrete placement and improved gain-before-feedback
IP57 dust-resistant, waterproof rated
Neutral, full sound quality for film, broadcast, speech, theater, and performance applications
Advanced 1.6 mm Shure Plex cable:
- Dual redundant ground in cable serves as secondary shield for unprecedented longevity
- Immune to memory effect and kinks
- Fully paintable with typical theater paints, pens, and polishes
Presence Cap included for tailored frequency response provides additional vocal clarity and presence (3-4 dB boost near 10 kHz)
Available in three colors: Black, Cocoa, Tan
Available in two connector types: TA4F (mTQG) and LEMO
Kit includes the following accessories: Case, Foam Windscreen, Snap-fit Windscreen, Single Tie Clip, Sticky Mount, TQG Locking Collar (mTQG/TA4F SKUs only)

With an easy-to-wear headset frame, DuraPlex DH5 features a neutral, full sound quality that lives up to the highest audio standards on any stage or broadcast studio. Also available as a lavalier, DuraPlex has been extensively tested to ensure an IP57 dust-resistant, waterproof rating*. The exclusive 1.6 mm Shure Plex cable with DuraPlex won’t kink, offers virtually zero “memory effect,” is fully paintable, and simply lasts longer due to a dual redundant ground, which doubles as a secondary shield.

In the theater, onstage, or on television, you can depend on the DuraPlex DH5 headset microphone for consistent professional sound, durability, and longevity.

*IP Code, published by the International Electrotechnical Commission (IEC), rates the degree of protection against dust (first number) and water (second number). An IP57 rating classifies DuraPlex as follows:

5 (Dust) – Ingress of dust is not entirely prevented, but it does not enter in sufficient quantity to interfere with the satisfactory operation of the equipment.
7 (Water) – Ingress of water in harmful quantity shall not be possible when the enclosure is immersed in water up to one meter for 30 minutes.

Show More Show Less

Note:

All specification values are based on using a typical bodypack with 5 V bias input or the RPM400MTQG preamplifier. When using the RPM400LEMO amplifier, refer to the RPM400LEMO specifications.
All specifications measured with a 48 Vdc phantom power supply. The microphone operates at lower voltages, but with slightly decreased headroom and sensitivity.

Microphone Capsule: MEMS
Polar Pattern: Omnidirectional
Frequency Response: 20 Hz to 20 kHz
Sensitivity: -42.5 dBV at 1 kHz [1]
Self-Noise, A-Weighted, Equivalent Acoustical: 31 dB SPL-A
Signal-To-Noise Ratio [2]: 63.0 dB
Maximum SPL [3]: 132.0 dB SPL,1 kHz at 1% THD, typical
Dynamic Range: 101.0 dB typical
Microphone Current Draw: 220 µA, maximum
Bias Voltage (Recommended Operating Voltage): 5 V DC, 2.6 V DC minimum
Housing: Molded ABS
Polarity

MTQG	Positive pressure on diaphragm produces positive voltage on pin 3 with respect to pin 1
LEMO	Positive pressure on diaphragm produces positive voltage on pin 3 with respect to pin 1

Cable Diameter: 1.6 mm
Cable Length: 66 in. (1.67 m)
Net Weight