SHURE MX184
Supercardioid Lavalier Microphone
The MX184 premium supercardioid lavalier microphone brings a new level of sophistication to personal voice reproduction. Like all Microflex family microphones, this lavalier uses an interchangeable condenser cartridge, meaning there will always be a lavalier to suit your application.
8,424,000đ
Viewed743 times
What is the MX184 best suited to?
The MX184 supercardioid miniature lavalier condenser microphone is designed for use in speech applications such as broadcast presenting, speeches, lectures and for use in houses of worship.

All the Microflex series of microphones use interchangeable cartridges (sold separately) which means you can swap between cardioid, supercardioid and omnidirectional condenser cartridges simply by screwing them on to the top of the lavalier mic.

The MX184 is designed for wired use and includes an in-line preamplifier and a 1.2m cable with TA4F connector. If you wish to go wireless, choose the WL184 which is the same microphone but without the pre-amplifier and connects directly into any Shure wireless bodypack.

FEATURES
- Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
- Interchangeable cartridges that provide an optimal choice for each application
- Rotatable tie-clip that pivots in 90 degree increments for placement flexibility
- Supplied snap-fit foam windscreen that controls breath noise and stays on securely
- Balanced, transformerless output for increased immunity to noise over long cable runs
- Supplied dual tie clip holds two microphones for dual miking applications
- Type: Electret Condenser
- Frequency Response: 50–17000 Hz
- Polar Pattern
|
MX183 |
Omnidirectional |
|
MX185 |
Cardioid |
|
MX184 |
Supercardioid |
- Output Impedance: 180 Ω
- Output Configuration: Active Balanced
- Sensitivity (@ 1 kHz, open circuit voltage)
|
Cardioid |
–35 dBV/Pa(18 mV) |
|
Supercardioid |
–34 dBV/Pa(21 mV) |
|
Omnidirectional |
–28 dBV/Pa(42 mV) |
- Maximum SPL (1 kHz at 1% THD, 1 kΩ load)
|
Cardioid |
124 dB |
|
Supercardioid |
123 dB |
|
Omnidirectional |
117 dB |
- Self Noise (A-weighted)
|
Cardioid |
28 dB SPL |
|
Supercardioid |
27 dB |
|
Omnidirectional |
21 dB SPL |
- Signal-to-Noise Ratio (Ref. 94 dB SPL at 1 kHz)
|
Cardioid |
66 dB |
|
Supercardioid |
68 dB |
|
Omnidirectional |
74 dB |
- Dynamic Range (1 kΩ load, @ 1 kHz): 96 dB
- Common Mode Rejection (10 Hz to 100 kHz): 45 dB, minimum
- Clipping Level at 1% THD: –6 dBV (0.5 V)
- Polarity: Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector
- Environmental Conditions
|
Operating Temperature |
–18–57°C (0–135°F) |
|
Storage Temperature |
–29–74°C (–20–165°F) |
|
Relative Humidity |
0–95% |
- Power Requirements: 11–52 V DC, 2.0 mA
- Cable: 1.2 m (4 ft)

